U. S. Solid normally closed (N/C) electric solenoid valve is constructed with a durable brass body, two-way inlet and outlet ports with one-quarter inch (1/4″) female threaded connections, and heat and oil resistant Viton seals.
Suitable for use with hot or cold water, gas, air, very low viscosity fluids (< 20 cst), oils and hydrocarbons, gasoline, kerosene, or diesel fuel, e.g. Suitable for outdoor use. Not for use underwater. Customers chose this general purpose valve for: do-it-yourself projects, moderate temperature applications, water exchange for aquarium, air horn, or bleeding moisture from an air tank.
Pipe Size: 1/4″
Flow Aperture: 2.5 mm
Body Material: Brass
Gasket / Diaphragm / Seal: Viton
Thread: NPT or G (optional)
Operation Type: Direct Lift Valve
Operation Mode: Normally Closed
Electric Current: Direct
Voltage: 24 volts,+ or – 10%
Current: 0.583 A
Power rating: 14 Watts
Specifications for Pressure, Flow, Temperature
Operational pressure range：
Air, Water, Gases: 0 to 101 PSI
Oil: 0 to 72 PSI
Flow capacity: 0.23 gallons per minute (GPM) of water at 60 oF with a pressure drop of 1 PSI
Flow value: 0.23 Cv
Temperature, Minimum:14 degrees Fahrenheit (-10 degrees Celsius)
Temperature, Maximum: 248 degrees Fahrenheit (120 degrees Celsius)
Air, water, oil, gas, Diesel fuel, kerosene etc. Can not be used in strong acid, strong base, waste water, industrial gas and other media containing many impurities.
1. OVERHEATING WARNING: Not designed for continuous operation(not a 100% duty cycle). While energized, under normal operating conditions, solenoid valve will get HOT.
The coil will reach a maximum temperature of about 80 degrees celsius. It is fully complied with national standard: JB/T7352-2010. If energized continuously for more than 8h the coil may burn.
2. This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm.